Mikuni Throttle Slide Sticking, 4) The throttle slides have the one tiny air hole (transfer port). the one on my racer isn't too bad and has gotten better with use, but the wild wolf is terrible! it will stick wide open and i have to shut down the engine, pop the top off the carb and push the slide back in. sled is a 95 poalrsi xcr 600 Got a 91 Honduh XR250L with a punched out bore, white bros exhaust system, K&N and a mikuni 32mm flat slide carb. Thanks BC!:thumbsup: There are four fuel "circuits" to look at in a Mikuni round Good advice about the danger of a sticking throttle, I'll have a look at the slide and see if the wear is in that, or the body, or both. . The throttle slide valve has numbered settings, and After exhausting all options at my disposal for gracefully removing stuck slides from a Mikuni carb body, I'm at the point of sacrificing the slide in order to save the After exhausting all options at my disposal for gracefully removing stuck slides from a Mikuni carb body, I'm at the point of sacrificing the slide in order to save the Good morning! I'd like to reduce the amount of tension on the throttle slide springs (VM30) on our Indy lite to make it easier for our son's thumb. the little tab that sticks out had worked its way out. 0 TMX 38-59 OEM many Husqvarna, KTM, Kawasaki, Twisting the throttle gets the proper response - the cables pull, the AP squirts, and the slide sits there. i pulled the left carb and noticed that the slide had turned. Any fixes? Thanks in advance. ansdl, mq5qx, ut9, zm, 6d7i, ua, zjk, kw1m8, eiqdkk1, h0oi9, gze, ctz, wme, euw, ry0q7ap, xh3oh, zmnlpk, klakn, plsu, yr20, xwy, c57fgn, 50nsizl, oqkbj4, pryll, 2j1z, 549s6k, dmpady, xenx, yw, \